===============================================================================
                                W A V E C O M
===============================================================================

OPEN AT V2.00
Updated : December 19th, 2002

===============================================================================

(To print this file : use Notepad and remove all margins and default header.)

                       ---------------------------------
                              Content of this file
                       ---------------------------------

Telemetry Sample application description

I.      Changes
II.     Application description



   
I - Changes
===========

* 19/12/02  -   V2.00
  Initial revision.


II - Application description
============================

 This application checks the GPIO 0 state every 3 seconds. On a state change,
it sends a SMS report to the number set by the application (via the "AT+TEL"
command) :

        (Parameters Command)
        AT+TEL=<number>
        OK or +CME ERROR: 3

            <number> : destination number to send the SMS Report to
                       (Max length : 20)

 This command is available only once the "+WIND: 4" indication is received.
After this command is used, the GPIO 0 is allocated, and its state read on a
cyclic timer. On a state change, a report SMS is sent to the number set by the
AT+TEL command.
